Showing {{SearchResultCount}} Results for: "{{SearchValue}}"

Popular Berger Products

No results

Popular Paint Colours

No results

Be Inspired

No results


Information for the following surfaces:

Sandstone

 Concrete

 Limestone

 Exposed aggregate

 Blue stone

 Brick

 Natural and engineering stone

 

        

STEP 1

To start, use Berger Jet Dry Active Clean to clean the surface. Berger Jet Dry Active Clean is formulated to clean tough oil and grease stains from concrete and paving surfaces.

Follow the dilution table on pack, and apply using a stiff bristle broom. Allow the solution to sit on the surface for 15 minutes without drying out.

Clean the surface thoroughly with water and allow to dry before proceeding.

Bare concrete will need to be etched using Berger Jet Dry Active Etch. If you are coating natural stone, check if the surface is sufficiently prepared to be sealed by performing a simple water bead test. Drop beads of water on the surface. If the water absorbs into the surface, it is ready to be coated. If the water beads on the surface, it is not porous enough for a sealer to penetrate the surface, and will need to be etched.

STEP 2

Use Berger Jet Dry Active Etch to etch the surface. Berger Jet Dry Active Etch roughens the surface to provide a key for a coating to adhere to. Berger Jet Dry Active Etch is a safer alternate to hydrochloric acid, and its rinse residue will not harm plants.

Mix Berger Jet Dry Active Etch into water, following the dilution instructions on pack. Apply using a stiff bristle broom. Allow the solution to sit on the surface for 15 minutes. Clean the surface throughly with water and allow to dry. Check the surface is ready to be painted by performing another water bead test. If the water beads on the surface, it is not sufficiently prepared and you'll need to complete the etching step again. The surface should feel like 180 grit sandpaper. For further help, contact Berger Customer Service on 0800 800 424, available 7 days.

Berger Jet Dry Stone & Paving Sealer in NATURAL

Use Berger Jet Dry Stone & Paving Sealer in Natural to maintain the natural appearance of the surface. Apply 1 coat for a natural finish, and apply 2 coats for a soft satin finish. Berger Jet Dry Stone & Paving Sealer in Natural is a true penetrating sealer and may be driven on after 12 hours of application.

Once you have chosen your desired product, apply using brush, roller or spray, according to directions on pack.

Maintain the look of natural stone concrete and paving

 

BERGER JET DRY STONE & PAVING NATURAL

NATURAL STONE PROTECTION

  • Surfaces are easier to clean, and stay clean for longer

  • Apply 1 coat to maintain the look of your surface, and apply 2 coats for a soft satin finish

  • Fast drying, ready to walk on in 2 hours, drive on in 12 hours

  • Water wash up and low odour